Dirt, pollen, and bird droppings can cut your solar output by up to 25%. Our pure-water system safely restores full efficiency — no harsh chemicals, no scratching.
Every solar panel cleaning uses pure deionised water and soft brushes — no chemicals, no risk to coatings or warranties, and full output restoration.
Deionised, mineral-free water delivered through soft brushes cleans panel glass completely and dries spot-free without leaving any residue that would reduce output.
Zero detergents, soaps, or cleaning agents used. Pure water only — protecting your panel coatings, preserving your manufacturer warranty, and keeping runoff safe.
Solar-specific soft-bristle brushes remove bird droppings, pollen, dust, and soiling without scratching anti-reflective coatings that are critical for panel efficiency.
Monocrystalline, polycrystalline, and thin-film panels all safely cleaned. We adjust brush pressure and technique for different panel types and mounting configurations.
Our technicians are trained for safe roof access and follow WorkSafeBC protocols on all roof pitches. Water-fed pole systems allow ground-level cleaning on most residential arrays.
We note panel condition, soiling levels, and any physical damage observed during cleaning. Our report helps you track output recovery and identify panels needing attention.
A layer of pollen, dust, and bird droppings absorbs and scatters light before it reaches the cells. Cleaning restores up to 25% of lost generation output directly.
Most panel manufacturers recommend annual professional cleaning and specify no chemicals or abrasives. Our pure-water method keeps you in compliance with warranty requirements.
Soaps and detergents leave residue films that reduce light transmission and can degrade anti-reflective coatings over time. Pure water leaves the panel surface pristine.
Solar panels are a significant investment. Annual cleaning maximises return by keeping generation at design capacity and extends panel life by removing corrosive bird dropping acids.
From site check to full solar output — here's exactly what to expect.
Quote based on panel count and roof access. We confirm the safest cleaning method.
Booked for early morning or overcast conditions for best cleaning results.
Every panel cleaned with deionised water and soft brushes. No chemicals, no scratching.
Condition report sent. Your panels are back to generating at full rated capacity.
Studies show that dirty solar panels can lose between 15-25% of their energy output depending on the level of soiling. In Fraser Valley, pollen season combined with bird droppings and general atmospheric dust is enough to cause measurable output loss that accumulates year-round.
We use a pure, deionised water system with soft-bristle brushes specifically designed for solar panels. Pure water dries without leaving mineral spots, and the gentle brush removes soiling without scratching the anti-reflective coating on panel glass. No soaps, detergents, or chemicals are used.
We recommend solar panel cleaning at least once per year in Fraser Valley, ideally in late spring after pollen season ends. Properties with birds nearby, trees overhead, or near agricultural activity may benefit from twice-yearly cleaning to maintain maximum output through the summer generation season.
DIY solar panel cleaning carries significant risk — roof access hazards, using the wrong water or products that void warranties, and risk of damaging anti-reflective coatings. Professional cleaning ensures panels are cleaned correctly, safely, and without voiding manufacturer warranties.
No. Solar panels do not need to be shut off for exterior cleaning with our pure-water method. We do recommend cleaning in the early morning or on overcast days when panels are cooler, as cleaning hot panels with cold water can cause thermal shock on some older panel types.
Restore your solar output with professional pure-water panel cleaning across the Fraser Valley. Response within 2 hours.
(604) 378-2130